|Tip cleaner having both wire-type and sponge-type advantages|
|Prevents solder from splashing when cleaning.|
|Inserting just the tip into the receptacle completely prevents solder from splashing.|
|Two-types of brushes control how much solder is removed.|
|Solder removal status can be adjusted by plastic brushes and metallic brushes.|
|With wire-type cleaners, excessive amounts of solder remain on the tip, which causes solder to splash when soldering. With sponge-type cleaners, oxidation is promoted, which causes shorter tip life.
A tip cleaner with both wire-type and sponge-type advantages eliminates the above problems when soldering.
|Comparison of how much solder is removed by the different cleaning methods<|
|* The photos show the iron tips T12-D24.|
|Minimizes decrease in temperature of the tip while cleaning.|
|Inserting the tip turns the brush automatically; no need to switch it on and off.
Reduces the tip cleaning time between soldering works to increase work efficiency.
The electric rotary cleaner provides a uniform final cleaning status with no differences between individuals.
|Comparison of decrease in tip temperature by cleaning method|
|If decrease in temperature is small, the time for a single cleaning also becomes short. Because cleaning is performed many times per day, the overall working time can be also shortened.|
|Time for single cleaning (The time for a single cleaning is measured as the time until the tip temperature reaches the set temperature after cleaning.)|
|The low-noise design relieves stress due to noise during work.|
|* This cleaner is very quiet in comparison with competitor’s electric tip cleaner.|
|Easy to maintain|
|Brushes can be replaced without removing any screws.|
|Solder left inside is stored in “Solder waste collector”.|
|Solder does not splash all over the inside of the main body.|
|Safe design prevents brushes from turning unexpectedly during replacement.|
|The brush cannot be replaced unless the AC adapter is unplugged.|
|This tip cleaner can be attached to HAKKO iron holders HAKKO FH-101, FH-200 and FH-201.|
|This tip cleaner can be attached to any of the above 3 iron holders using just 2 screws. For other iron holders, this tip cleaner can be placed next to the iron holder.|
|* The HAKKO FT-710 itself cannot be used as an iron holder. Be sure to use it together with an iron holder.|