We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
T20-J02 Angled Soldering Tip R0.2 /30° x9mm
Excluding VAT
How to use Shape J and examples
This shape differs from Shape B and I by bending the tip end and is capable of soldering by applying the tip in 2 ways: face and point. It is used for drag soldering and correction of bridging.
Soldering tiny chip parts such as 0603
![]() |
Lay down the end pad section and put the tip to the land. Some IC is specified by manufacturer not to be touched electrode by tip end. |
Drag soldering
![]() |
Lay down the end pad section and drag the tip slowly. Apply flux to leads and land pads before soldering. It prevents the troubles such as solder bridge. |
Correcting Bridging
![]() |
If the bridge amount is small Stand the tip on end and drag the tip slowly. Please operate with clean tip. |
![]() |
If the bridge amount is large
|
Soldering at the narrow pitches
|
You can hold the grip with the natural angle (Refer to A) while soldering with Shape J, which has the same high-angle of tip end (Refer to B) as Shape I.
|