T20-D6 Chisel Soldering Tip 6mm x 1.2mm 11.5mm

£31.73
Excluding VAT
In stock
SKU
HT20-D6
T20 Soldering Tip Shape-6D For the FX-8301. FX-8302
click to enlarge image

How to use Shape D and examples

This shape is capable of any soldering by placing the tip end in 2 ways: line and face. Therefore it requires soldering skill such as Shape B.

Line example

Shape D is also available for soldering at narrow pitches by placing the tip end in Line.
T12 series has ten kinds of Shape D which has the variation of Line width from 0.5mm to 1.2mm.

Shape D has the special application of Heavy Duty Type.
Shape D has the special application of Long Life Type.

Soldering tiny chip parts such as 0603

Put the tip end to the land.
* Soldering tip in the picture is T30-D06 with an N2 system iron for pre-heating effect.

Some IC is specified by manufacturer not to be touched electrode by tip end.

The other tip shapes are recommended.
Soldering tiny chip parts such as 0603

Soldering chip parts

Put the tip end to the land and drag the tip slowly while feeding solder.

Some IC is specified by manufacturer not to be touched electrode by tip end.

 

See the movie for further details,

The other tip shapes are recommended.
Soldering chip parts

Drag soldering

Put the tip end to the leads and drag it slowly.

Apply flux to leads and land pads before soldering. It prevents the troubles such as solder bridge.

 

See the movie for further details,
    Check the right timing to feed solder.

The other tip shapes are recommended.
Drag soldering

Pre-tinning lead wire

Put the cut surface to the lead and drag the tip slowly while feeding solder.

See the movie for further details,

Point soldering

PTH

1. Put the tip end to the land pad and PTH at one time to heat them.

2. Feed solder to form smooth fillet on the land pad.

QFP

Put the tip end to the leads and drag it slowly.

See the movie for further details,

The other tip shapes are recommended.
Point soldering

Soldering cup terminals

1. Put the cut surface to the lead and terminal at one time to heat them.

2. Feed solder to form smooth fillets.

Get rid of gold plating of terminal and pre-tin lead wire. It makes solder spread over the terminal easily and prevents soldering defect. For further information, see “Soldering cup terminals”.

Melting and removing coil coatings

1. Put the cut surface to the coil and terminal at one time to heat them.

2. Feed solder.

The other tip shapes are recommended.
Melting and removing coil coatings