T15-BCM3 Bevel Soldering Tip 3mm/45° x 10mm
How to use Shape BCM/CM and examples
In Shape BCM/CM, surface tension of solder in the hollow section:
When the tip is placed, solder left in a hollow section absorbs solder in the bridge section.
Since the pulling force due to surface tension of this type is stronger than that of Shape BC, solder is not left in unnecessary areas during drag soldering.
Feed solder on a hollow section and drag the tip along slowly.
Apply flux to leads and land pads before soldering. It prevents the troubles such as solder bridge.
1. Clean solder left in the hollow section by a cleaning sponge, etc.
A small amount of solder may be left in the hollow section.
2. Put the tip on the bridge section and drag it.