N2 system mechanism

Number and position of holes differs according to type of N₂ soldering iron.
This illustration depicts the HAKKO FM-2026.

What is the temperature of heated nitrogen gas?

In case of HAKKO FM-2026 (Station:HAKKO FX-951)

Test condition:

Measure at a point 2mm from the center of tip end with ø0.1CA sensor

Tip shape

T13-D24

Temperature

300℃ and 350℃

Temperature of nitrogen gas varies depending on tip shapes. Setting temperature (ºC) Flow rate of nitrogen gas (l/min.) Temperature of nitrogen gas (ºC) 300 0.5 210 1.0 250 1.5 260 2.0 263 2.5 260 350 0.5 230 1.0 240 1.5 300 2.0 320 2.5 305

Setting sample -Soldering station HAKKO FX-951 -N2 generator HAKKO FX-780: small-capacity type -N2 flow meter HAKKO FX-791

Please refer to above values, which vary depending on soldering condition.

In case of HAKKO FX-8302 (Station:HAKKO FX-838)

Test condition:

Measure at a point 2mm from the center of tip end with ø0.1CA sensor

Tip shape

T20-D24

Temperature

300ºC and 350ºC

Temperature of nitrogen gas varies depending on tip shapes.

Setting temperature (ºC) Flow rate of nitrogen gas (l/min.) Temperature of nitrogen gas (ºC) 300 0.5 225 1.0 235 1.5 240 2.0 175 2.5 160 350 0.5 275 1.0 300 1.5 300 2.0 225 2.5 200 Please refer to above values, which vary depending on soldering condition.

Setting sample -Soldering station HAKKO FX-838 -N2 generator HAKKO FX-780: small-capacity type -N2 flow meter HAKKO FX-791

Required equipments