Hakko WICK No Clean 1.0mm x 1.5m Desolder braid

Faster thermal transmission for superior performance at lower temperature and with lower wattage soldering irons.

Three different
Regular type : Rosin flux treated copper braid
Unflux type : Untreated copper braid
No clean type : Low residue flux treated copper braid
                        Using ESD SAFE package

 Trick to remove solder well with the desoldering wire

Wrong use of the desoldering wire may tear patterns from a PCB or damage discrete components. In order to prevent these problems, make sure to take the preventive measure below:

1. Apply a bit of solder to the tip of solder iron.
2. Apply a bit of solder to the tip of the desoldering wire. Cut the soldered tip of the wire at an angle of 45 degrees. Solder should remain attached.

Preliminary soldering improves heat conductance. 

Put the desoldering wire onto the soldering part.

Press the desoldering wire with the soldering iron on the wire

After melted with the heat of the soldering tip, the solder is sucked up into the desoldering wire

Remove the desoldering wire and soldering iron at the same time.