FX-901 Cordless Soldering Iron

£44.86
Excluding VAT
In stock
SKU
HFX901-01
  • The FX-901 is a cordless soldering iron solution ideal for field service technicians and for all your soldering projects and hobbies.
  • Cordless design makes this iron very handy to use virtually anywhere
  • Can operate above 315°C for up to 120 continuous minutes, unlike any other cordless soldering gun.
  • AA Batteries NOT included: Recommended Ni-MH batteries for optimal performance
click to enlarge image

Features

Handy design for cordless soldering

Quick&easy soldering tip replacement

  • The quick-release soldering tip can be easily replaced.

Selective battery

  • Various batteries including alkaline and nickel-hydrogen batteries can be used by changing the cartridge.

Easy soldering not only for hobby but for P.C. board processing

  • Powerful cord and handy cordless soldering iron.
  • Various soldering application is available such as P.W.B., field service and model or radio-controlled models.

Specifications

Model No.

FX-901

Power supply

AA×4 pcs. (not included)

Power consumption

Alkaline batteries : 6V (6W)
Nickel hydrogen batteries (2150mAh) : 4.8V (5W)

Standard tip

Shape-B (No.T11-B)

Battery life

Alkaline batteries : 60 minutes
Nickel hydrogen batteries (2150mAh) : 120 minutes

Total length

212mm

Weight

76g

[ Measurement conditions ]
- When using new batteries, performance will vary depending on batteries.
- The operating time was measured from when powered on until the temperature came down less than 300ºC which is supposed as minimum for soldering.
* When using the batteries except specified above, performance and hour operation will vary.
* Total length (w/o cap)
* Weight (w/o battery)

Usage/Applications

  1. INITIAL SET UP
    Put the soldering tip through the hole in the nipple, then insert them to the unit as shown in Figure 1.
    Turn the nipple approximately 90 degrees clockwise and screw it tightly on the unit. Be sure to secure the tip tightly. Attach the soldering tip while it is cold.

  2. INSERTING THE BATTERIES
    Slide down the release button to the UNLOCK position as shown in Figure 2. Remove the battery cartridge from the unit. Check the polarity and insert the batteries in the proper orientation.
    Place the upper side of the battery cartridge onto the guide of the unit, slide the cartridge, and set the release button to the LOCK position.

  3. HOW TO SOLDER
    Turn the power switch ON. The LED lamp lights up, and the soldering tip heats up to be soldered after 40 seconds.
    After soldering, be sure to turn the power switch OFF and attach the protective cap to the unit.

Soldering Iron with Protective Cap, Batteries not included.

Optional / Recommended Extras

Images

Part Number

Description

Availability

 photo:699-030620

699-030620

Nipple for the FX-901 (Set of 10)

Buy

Tech Tips