FT-700 Soldering Tip Cleaner and Polisher

Excluding VAT
Low stock -
Order soon

Soldering tip polisher best suited for the removal of oxidation on soldering tips
Oxidized films firmly sticking to tips are removed using a supplied brush
It prevents the shortening of service life of tips caused by oxidation

click to enlarge image


"Maintenance kit for oxidized soldering tips"
Especially suitable for soldering tips oxidized by Lead-free solder and high temperature solder
By using the brush and accessory "Chemical Paste"HAKKO FS-100:
Carbide and oxide can be removed without causing damage to the soldering tip
Diamnonium phosphate is not included
Power saving with 3 watts low consumption.
HAKKO FT-700 Tip Polisher / Tip condition before and after polishing with HAKKO FT-700 tip polisher


· Cleaning procedure
Oxidized tip
Oxidized tip
Use a temperature setting of around 350ºC. Cleaning is now completed.
Cleaning is now completed.
↓           右
Remove carbide and oxide.
右 Re-tin the tip.
Tin the tip.
(remove oxide)
右 酸化膜の除去。
Clean off chemical paste from the tip surface.
右 こて先にはんだをのせて酸化防止。
Tin the tip with solder.
Repeat the process twice or more until oxide is completely removed.

NOTE: When the tip temperature is over 400ºC, even if the oxidation film is removed by "HAKKO FT-700 tip polisher", the tip can turn to be oxidized quickly again.

When carbide and oxide cannot be removed by the above procedure
When carbide and oxide are hard, they sometimes cannot be removed even by the HAKKO FT-700. In this case, first use the brush which included in the unit as one of accessories and clean the tip by the above procedure.
Remove oxidation film using brush included with HAKKO FT-700  

When the brush is used, small scratches may be produced on the iron plating surface of the tip.
Do not always use the brush, but use only when oxidation cannot be removed by cleaning with HAKKO FT-700.

Packing List

Part No. Packing List
No.FT700 HAKKO FT-700 Tip Polisher, HAKKO FS-100 Paste, Brush: 1pc each


Model No. FT-700
Power consumption 3W (100V), 4.5W (110 to 120V, 220 to 240V)
Dimensions 70(W)×54(H)×101(D)mm
Weight 0.65kg

・Chemical Paste

Amount 10g
Ingredients Flux, tin(Sn) 50wt%(each)

* Weight (w/o cord)
* The flux component of chemical paste consists of Alicyclic amine hydrobromate, Aliphatic amine hydrobromate, Petrolatum, Wax. Make sure the tip is cleaned after use according to the cleaning procedure.
* Do not use the chemical paste for purposes other than restoring of the soldering tip.


Replacement Parts

  Part No. Name Specifications  
  FS-100 HAKKO FS-100 paste   Buy
photo:B3051 B3051 Brush   Buy
photo:B3052 B3052 Polishing brush (qty 2)   Buy

Tech Tips

Tech Tips

Category Title
Derek's Tech Tips Effective Cleaning & Maintenance of Soldering Tips